Turn a Pallet into a Strawberry Planter

0
15822

Last Updated on

The piece that made up the centre part of the pallet also has thick wooden blocks sandwiched between its front side and stubby planks on the other. Pull these blocks and stubby planks off but keep them in reserve – you’ll need them to complete the project. If there are nails sticking up after removing these pieces then either hammer them flat or remove them completely.

PalletStrawberryPlanter05

Fix the two end pieces to the middle part of the pallet. Screw in from the other side of the middle (bottom) piece.

The two end pieces will be the sides of your planter and the middle piece is the bottom. Though the image shows the structure right way up, it’s actually easier to flip it over in order to fix the bottom piece to the sides. You’ll want to screw or nail the bottom piece into the wooden blocks still attached to the side pieces.

PalletStrawberryPlanter06

You should have three to four of these pieces that were removed from the centre piece of the pallet. Separate them into individual blocks and planks.

This is easier said than done if you don’t have the right tools. Since pallet wood that has been heat treated can be brittle if you try to pull the plank off with the tongs of a hammer. If you have a heavy duty chisel then I recommend that you use it to separate the block and the plank and sever the nails in two. If you’re planning on doing any more pallet projects you could really save yourself a lot of tears and invest in one along with an iron mallet down at your local hardware store. If any of your pieces have bits of nails sticking out then try to hammer them flat.

PalletStrawberryPlanter07

If you’ve followed the directions in the first step and sawed in the middle between the long planks, then the little planks leftover from step four should all be approximately the same length. They will also be the same width you need to create the shorter sides of your planter. If your original pallet was the same size as mine then you’ll have four of these planks to make up two pieces for each side. The bottom planks for each of the shorter sides can be created by re-using the bits of wood you cut off the side pieces in step two. For a more pleasing and symmetrical effect, line the small side planks up with the planks along the front and back pieces.

Attaching the wooden blocks as feet can be a bit tricky and in the end I drove very long screws in sideways to attach them to the bottom of the planter. Putting feet on the piece will help with drainage and slow down the process of the bottom rotting. I think they also make the planter look nicer.

I can foresee some people finding pallets of slightly different sizes to mine and being left with less small planks and blocks in this step. In fact it’s more likely that you’ll end up with three of each rather than four, especially if you’re using a smaller pallet. In this case you’ll be cobbling together more scraps to make an additional side piece and having to find a fourth block to use as the last foot. In this case I’d look at removing one of the inner blocks from the side pieces to use.

PalletStrawberryPlanter08

Well almost :) Turn your planter right way up and have a look at it. Does it feel sturdy? Are the feet wobbly? Are there extra bits of wood sticking up that you could trim back? Once you feel the planter is complete then either plant it up as is or use a non-toxic outdoor wood paint to paint the exterior. Being wood, this piece will eventually rot down but some tlc now can help extend its life.

Don’t know where to get pallets? Get all the details on where you can find them here: Pallets – where do you get them?

To ensure that the pallets you found are safe to use, read all the facts – and instructions on how to dismantle pallets: Pallets – fact and fiction (or how to tell a safe pallet from a toxic one)

Ask first before taking any pallet. Branded pallets are not single use.

Thanks to Lovely Greens for this wonderful project!