Want to lower your electricity bill? This idea has given light to many third world countries, but even in the first world, free indoor lighting is good for the pocket.
This solution doesn’t require expensive solar equipment. All you need is a clear plastic soda bottle, water, and bleach! This green and sustainable concept is very easy to implement, and can provide approximately 55 watts of light!
This solar lighting idea will give you light in outdoor sheds or buildings not connected to the grid, as well as frequently used rooms in your home during daytime. This clever solution doesn’t just lower your electricity bill though. You’ll also decrease your carbon footprint, and help lessen the amount of garbage in the environment.
Have you got a spot where you can install one of these?
Click on any image to start lightbox display. Use your Esc key to close the lightbox.
Materials:
- Working Board
- Plastic Soda Bottles
- 2 Circular Patterns – larger circle with a diameter of the soda bottle, 3mm difference for the smaller circle
- 26 Gauge 10 x 10” Galvanized Metal Sheet
- Cement
- Rivets
- Sand Paper
- Bleach
- Water
- Covering for the Plastic Cap Bottle
Tools:
- Pencil/Marker
- Cordless Drill
- Glue Gun with Sika Sealant
- Riveter
- Hammer
- Chisel
- Curve Metal Sheet Cutter
Steps:
Cut approximately 9 x 10 inches of GI sheet (corrugated or flat).
At the center of the GI sheet, draw 2 circles.
Cut the inner circle.
Cut the 1 cm difference radially, making strips and bend upwards, perpendicular to the GI sheet.
Using sandpaper, scratch the surface around the upper third portion of the soda bottle where the GI sheet will be placed, to allow the rubber sealant to stick better.
Insert the bottle into the GI sheet until the upper third. Apply rubber sealant on the strips above and around the area below. Wait to dry.
Continued Page 2…
